Yamaha cannot be held responsible for damage caused by improper use or modifications to the device, or data that is lost or destroyed.Īlways unplug the USB cable from a computer or turn off the computer to turn off the device when the device is not in use. MIC/INST jacks (XLR-type) are wired as follows (IEC60268 standard): pin 1: ground, pin 2: hot (+), and pin 3: cold (-). The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620 If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If the antenna leadin is 300 ohm ribbon lead, change the lead-in to co-axial type cable. In the case of radio or TV interference, relocate/reorient the antenna. Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s. Relocate either this product or the device that is being affected by the interference.
If this product is found to be the source of interference, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of the following measures:
This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users manual, may cause interference harmful to the operation of other electronic devices.Ĭompliance with FCC regulations does not guarantee that interference will not occur in all installations. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class “B” digital devices. Failure to follow instructions could void your FCC authorization to use this product in the USA.ģ. Cable/s supplied with this product MUST be used. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.Ģ.
This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!
0 kommentar(er)
